networling switch SFP transceiver 80km 1G - XSFP-LD13/15-1G-80km

Features

1. Data-rate of 1Gbps operation

2. MQW DFB Laser, 1310nm, PIN

3. LVTTL logic level RX LOS

4. 80km transmission with SMF

5. Standard serial ID information compatible with SFP MSA

6. SFP MSA package with duplex LC connector

7. Very low EMI and excellent ESD protection

8. +3.3V single power supply

9. Operating case temperature:

10. Standard:0 to +70°C

11. Industrial: -40 to +85°C

Applications

Switch to Switch interface

Switched backplane applications

Router/Server interfac

ATM

SONT/SDH/PDH

FDDI

Fiber Channel

Other optical transmission systems

Standard

Compatible with SFP MSA

Compatible with IEEE 802.3z

Compatible with ANSI specifications for Fibre Channel

Compatible with FCC 47 CFR Part 15, Class B

Compatible with FDA 21 CFR 1040.10 and 1040.11, Class I

Compatible with Telcordia GR-468-CORE

RoHS compliance

Description

The SFP transceiver is high performance, cost effective module supporting data-rate of 1Gbps and from 10km to 120km transmission distance with SMF.

The transceiver consists of two sections: The transmitter section incorporates a FP laser. And the receiver section consists of a PIN photodiode integrated with a trans-impedance preamplifier (TIA). All modules satisfy class I laser safety requirements.

The optical output can be disabled by a TTL logic high-level input of Tx Disable. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver.

The standard serial ID information compatible with SFP MSA describes the transceiver's capabilities, standard interfaces, manufacturer and other information. The host equipment can access this information via the 2-wire serial CMOS EEPROM protocol. For further information, please refer to SFP Multi-Source Agreement (MSA).

The SFP transceivers are compatible with RoHS.

Absolute Maximum Ratings